Speedometer Under Reading Causes: Causes, Checks & Fixes

On this page, speedometer under reading causes is the case in point: A speedometer that reads wrong has a cause, and the cause decides the fix. The most common cause is a tyre diameter change: the dial was calibrated for the original size, and a larger tyre makes it read low while a smaller tyre makes it read high, by exactly the diameter percentage. Other causes are wear and pressure, a previous recalibration for a different size, and faults in the sensor or the instrument cluster. This page works through the diagnosis — how to measure the error, how to tell a calibration error from a fault, and what to do about each — with a worked example using 205/55R16 (631.9 mm) and 215/55R16 (642.9 mm), a +1.74% change.

Taking speedometer under reading causes as the case in point: The first step is always measurement: compare the dial with GPS speed at a steady speed on a straight road, and work out the percentage from the tyre sizes. If the error is the same percentage at every speed, it is a calibration error and the formula on this page predicts it exactly. If the needle jumps, sticks or drops to zero, it is a fault and the vehicle needs diagnosis rather than recalibration. The sections below cover the formula, the tables, the common causes in detail, the GPS check and the fixes — with the disclaimer below applying throughout.

This is a calculation, not a safety approval. Always check your vehicle's door-jamb placard, load index and speed rating, and confirm fitment with a tyre professional before fitting a different tyre size.

How the speedometer error is calculated for speedometer under reading causes

Work it out in two steps. Step one, the percentage: error % = (new diameter − old diameter) ÷ old diameter × 100, using the nominal new-tyre diameters computed from the size codes. Step two, the actual speed at any indicated speed: actual speed = indicated speed × (new diameter ÷ old diameter). A tyre that is 2% larger in diameter gives an actual speed 2% above the indicated speed — 71.4 mph actual at an indicated 70 mph — and a tyre 2% smaller gives 68.6 mph actual at the same indicated speed. The odometer follows the same percentage, so the mileage it records is also out by that amount. All the tables below are built from those two formulas with the diameters stated. That is the point this page works through for speedometer under reading causes.

What the speedometer actually measures for speedometer under reading causes

The speedometer does not measure speed directly. It counts wheel revolutions — from a sensor on the gearbox output, a wheel-speed sensor or the ABS system, depending on the vehicle — and multiplies by the rolling circumference the manufacturer programmed in. That circumference belongs to the original tyre size, so fitting a different diameter changes the distance covered per revolution while the speedometer keeps using the old figure. The result is a fixed percentage error: if the new tyre is 2% larger in diameter, the actual speed is 2% higher than the indicated speed at every speed, and the odometer under-records by the same 2%. The error does not grow or shrink with speed; it is the same percentage at 30 mph and at 70 mph, which is what the tables below show. That is the point this page works through for speedometer under reading causes.

speedometer under reading causes: Worked example: 205/55R16 to 215/55R16

205/55R16 measures 631.9 mm in overall diameter and 215/55R16 measures 642.9 mm. The error % is (642.9 − 631.9) ÷ 631.9 × 100 = +1.74%. At an indicated 30 mph the actual speed is 30 × (642.9 ÷ 631.9) = 30.5 mph; at 50 mph it is 50.9 mph; and at 70 mph it is 71.2 mph. The odometer is out by the same 1.74%: it records 98.29 miles for every 100 miles actually driven. The diameter change of 1.74% is inside the ±3% guideline commonly used for keeping speedometer error small, which is why this pair is a useful example — a larger change, such as 235/65R17 (737.3 mm) to 265/70R17 (802.8 mm), is +8.89% and gives 76.2 mph actual at an indicated 70 mph. That is the point this page works through for speedometer under reading causes.

speedometer under reading causes: Indicated vs actual speed: the worked example

Taking speedometer under reading causes as the case in point: Error: +1.74%. Actual speed = indicated speed × (642.9 ÷ 631.9).

Indicated speed Actual speed Difference
30 mph 30.5 mph +0.5 mph
50 mph 50.9 mph +0.9 mph
70 mph 71.2 mph +1.2 mph

On this page, speedometer under reading causes is the case in point: The table is read from the indicated speed: find the dial reading and read across for the actual speed. The difference column is the amount by which the car is travelling faster than the dial shows, and it grows with speed because the error is a percentage. A 1.74% error is 0.5 mph at 30 mph and 1.2 mph at 70 mph — small in both cases, but the direction is the one that matters, because the car is going faster than the driver believes. Check the door-jamb placard for the specified size and confirm fitment with a tyre professional before fitting a different tyre size.

speedometer under reading causes: Common causes of a wrong speedometer

Taking speedometer under reading causes as the case in point: Tyre size is the most common cause of a speedometer error, but it is not the only one. Worn tyres have a smaller diameter than new ones, so a speedometer calibrated for new tyres reads slightly high as the tread wears — the effect is small, typically well under 1%, but it is real. Under-inflation reduces the effective rolling radius and has the same direction of effect, while over-inflation increases it. A different final-drive ratio does not change the speedometer reading itself, because the sensor measures wheel speed rather than engine speed, but a speedometer drive gear change or a recalibration done for a previous tyre size will leave the dial wrong for the tyres now fitted. And on older vehicles a worn speedometer cable or a failing sensor can make the needle wander or stick, which is a fault rather than a calibration error and needs repair rather than recalibration.

speedometer under reading causes: How to fix a speedometer error

There are four common ways to correct a speedometer after a tyre change, and the right one depends on the vehicle. A handheld programmer or diagnostic tool can change the programmed tyre size on many modern vehicles, which corrects both the speedometer and the odometer at once. A speedometer drive gear — a small gear in the gearbox — does the same job mechanically on older vehicles, and the replacement gear is chosen from the diameter ratio. An inline calibrator, wired into the speed sensor signal, can scale the signal on vehicles where neither of the above is possible. And a dealer recalibration uses manufacturer software to change the setting where it is locked to franchised tools. Before spending money on any of them, measure the error against GPS at a steady speed so the correction needed is known, and confirm the method suits the vehicle — the wrong tool for the vehicle wastes the money and leaves the dial wrong. That is the point this page works through for speedometer under reading causes.

Common mistakes with speedometer error for speedometer under reading causes

Mistakes usually start with the wrong reference. The first is comparing the dial with another vehicle's dial — both can be out by the same amount. GPS speed, measured at a steady speed on a straight road, is the practical reference, though it has its own limits at low speed and on hills. The second mistake is treating the error as a fixed mph figure: a 3% error is 0.9 mph at 30 mph and 2.1 mph at 70 mph, so a single-speed check does not describe the whole picture. The third is forgetting that most speedometers already read slightly high from the factory, so the error after a tyre change is measured from that baseline, not from zero. And the fourth is the dangerous one: fitting larger tyres makes the dial read low, so the car is going faster than the driver believes, and driving to the indicated limit in that condition means exceeding it. That is the point this page works through for speedometer under reading causes.

Related pages for speedometer under reading causes

Frequently asked questions

How do I calculate speedometer error for speedometer under reading causes?

Taking speedometer under reading causes as the case in point: Use error % = (new diameter − old diameter) ÷ old diameter × 100, then actual speed = indicated speed × (new diameter ÷ old diameter). The worked example above uses 205/55R16 (631.9 mm) and 215/55R16 (642.9 mm), a +1.74% change, and the speedometer error calculator runs the same formula with your own sizes.

How much can a speedometer be out?

Taking speedometer under reading causes as the case in point: It depends on the tyre change. A 1% diameter change is 0.7 mph at an indicated 70 mph; a 3% change is 2.1 mph; an 8.89% change, such as 235/65R17 to 265/70R17, is 6.2 mph at an indicated 70 mph. In the UK the law requires that a speedometer never under-reads and may over-read by up to 10% plus 4 km/h.

Why is my speedometer wrong after new tyres?

On this page, speedometer under reading causes is the case in point: The usual reason is a different diameter from the size the vehicle was calibrated for: a larger tyre makes the dial read low and a smaller tyre makes it read high, by the diameter percentage. Other causes are wear, pressure, a previous recalibration for a different size, or a sensor fault. Measure the error against GPS at a steady speed to find out which it is.

How do I check my speedometer against GPS?

Drive at a steady speed on a straight, level road and compare the dial with a GPS speed reading. GPS is least reliable at low speed, while accelerating or braking, and on hills or in tunnels, so take the reading at a steady cruise. A difference that is the same percentage at several speeds is a calibration error; a needle that jumps or sticks is a fault. That is the point this page works through for speedometer under reading causes.

Does tyre wear affect the speedometer?

On this page, speedometer under reading causes is the case in point: Yes, slightly. A worn tyre has a smaller diameter than a new one, so the speedometer reads slightly high as the tread wears — typically well under 1% over the life of the tyre. Under-inflation has the same direction of effect by reducing the effective rolling radius. Both are small compared with a size change, but they are real.