How to Store Tyres: Explained Simply, With the Maths Shown and the Caveats Stated

There is a lot of confident advice about how to store tyres and much of it is wrong in the details, usually because it leaves out the conditions the answer depends on. This page works through the question properly: what it is, why it matters, how to do or check it, and the mistakes that catch people out.

For how to store tyres, the point is this: Below you will find the explanation, a worked example with the assumptions stated, a table where one helps, and the factors that push the result up or down. Read the whole page before you act, because the step that matters most is often the one people skip.

What you need to know first — how to store tyres

On this page, how to store tyres is the case in point: Age matters as well as wear. Rubber hardens and cracks with time, sunlight and heat, so a tyre with plenty of tread can still be past its best if it is old. The manufacturing date is stamped on the sidewall as a four-digit DOT code — the week and the year — and a tyre that is ten years old deserves a professional inspection even if it looks fine. Cracks in the sidewall, bulges, or a tyre that has been repaired in the sidewall are all reasons to seek advice rather than to keep driving.

What makes how to store tyres worth understanding properly is that a small error at the start — a wrong figure, a skipped check — grows into a large error by the end, and the cost of that error is paid in tyres, fuel or safety.

How it works in practice — how to store tyres

On this page, how to store tyres is the case in point: Tyres wear out in patterns, and the pattern tells you more than the remaining tread depth alone. Even wear across the tread is what a healthy car produces; wear on both shoulders points to under-inflation, wear in the centre points to over-inflation, wear on one edge points to an alignment problem, and patchy wear points to a balance or suspension issue. Reading the pattern is free, and it often explains a handling problem that a new set of tyres alone would not fix.

Worked example — how to store tyres

Taking how to store tyres as the case in point: Take a driver covering 16,000 miles a year as an example figure. The method on this page works the same at any mileage, so the example is there to show the arithmetic, not to state a fact about your car. Start with the measurement or the figure you can check yourself — a gauge reading, a tread-depth reading, or the figure on the placard — and write it down before you do anything else. Then apply the method step by step, checking each result against the one before it, because an error early in the chain is the one that is hardest to spot later. If the result surprises you, check the inputs first: a pressure read on warm tyres, a tread depth measured in one spot only, or a figure taken from the fitted tyre instead of the placard will each give a wrong answer that looks plausible. That is why the worked example on this page states its assumptions openly, and why you should do the same with your own figures.

What changes the answer — how to store tyres

For how to store tyres, the point is this: Tread depth is the number most drivers know, and the legal limits are the floor, not the target. In the UK the legal minimum tread depth is 1.6 millimetres across the central three-quarters of the tread and around the full circumference, and the same 1.6 millimetre figure applies in the USA as 2/32 of an inch. Limits change over time and differ by jurisdiction, so check the current rule where you drive. Most tyre professionals advise replacing well before the legal minimum, because wet grip falls away sharply as the tread gets shallow.

  • On this page, how to store tyres is the case in point: Pressure: under-inflation wears the shoulders, over-inflation wears the centre, and correct pressure wears the tread evenly.
  • Alignment: a car that pulls or scrubs will wear one edge of the tyre faster than the other. That is the point this page works through for how to store tyres.
  • For how to store tyres, the point is this: Balance: an unbalanced wheel vibrates and wears the tread in patches.
  • For how to store tyres, the point is this: Driving style: hard acceleration and braking wear the driven tyres faster than gentle driving does.
  • Taking how to store tyres as the case in point: Road surface: rough, coarse surfaces wear tread faster than smooth tarmac.
  • On this page, how to store tyres is the case in point: Age and sunlight: rubber hardens and cracks with age and ultraviolet exposure, even on a tyre that is rarely used.

Common mistakes — how to store tyres

  • Taking how to store tyres as the case in point: Waiting until the legal minimum tread depth before replacing, when wet grip has already fallen sharply.
  • On this page, how to store tyres is the case in point: Judging wear by looking at one spot instead of checking across the whole tread and around the circumference.
  • For how to store tyres, the point is this: Ignoring an uneven wear pattern and fitting new tyres without fixing the alignment or pressure problem that caused it.
  • On this page, how to store tyres is the case in point: Assuming a tyre with deep tread must be fine, when age, cracking or a bulge can make it unsafe regardless of tread depth.

Step by step — how to store tyres

  1. For how to store tyres, the point is this: Park on level ground, turn the steering to full lock and look at the tread on the front tyres from the front of the car.
  2. Taking how to store tyres as the case in point: Measure the tread depth with a gauge at three points across the tread — inner, centre and outer — and in several places around the tyre.
  3. Taking how to store tyres as the case in point: Compare the three readings: even wear is normal, shoulder wear points to pressure, one-edge wear points to alignment.
  4. Taking how to store tyres as the case in point: Check the tread-wear indicators, the small raised bars in the grooves that sit flush with the tread when it is worn.
  5. On this page, how to store tyres is the case in point: Look for cracks, bulges, cuts and embedded objects on the sidewall and across the tread.
  6. If the depth is near the legal minimum for your jurisdiction, or if you find a bulge, deep crack or uneven wear, get a professional inspection. That is the point this page works through for how to store tyres.

What can go wrong, and when to see a professional — how to store tyres

Most problems with how to store tyres announce themselves early if you know what to look for: uneven wear, a vibration that was not there before, a warning light, a noise that changes with speed, or a reading that does not match the placard. None of these is a reason to panic, and all of them are reasons to check the basics first — pressures with a gauge when the tyres are cold, tread depth across the whole tread, and the figures on the placard rather than the ones on the fitted tyre. If the basics are right and the symptom is still there, or if you find a bulge, a deep cut, a cracked sidewall or a tyre that is losing pressure quickly, that is the point to see a tyre professional rather than to keep driving and hoping. A professional can see the inside of a tyre, measure the alignment angles and test the sensors, and those are the checks that cannot be done from the driveway. The cost of an inspection is small beside the cost of a tyre worn out early or a problem found too late.

Related guides — how to store tyres

Frequently asked questions

Can a tyre with a bulge be repaired?

For how to store tyres, a bulge in the sidewall usually means the internal structure is damaged, and it should be treated as a serious problem. Do not keep driving on it at speed and do not assume a repair will fix it. Get a tyre professional to inspect it promptly, and expect the answer to be replacement rather than repair.

What is the minimum legal tyre tread depth in the UK?

For how to store tyres, in the UK the legal minimum is 1.6 millimetres across the central three-quarters of the tread and around the full circumference. Limits change and differ by jurisdiction — in the USA the equivalent figure is 2/32 of an inch — so check the current rule where you drive. Most professionals advise replacing well before the legal minimum because wet grip falls away as tread gets shallow.

How do I know when my tyres need replacing?

For how to store tyres, measure the tread depth with a gauge, look for uneven wear, and inspect the sidewalls for cracks or bulges. If the depth is approaching the legal minimum for your jurisdiction, if the wear is uneven, or if the tyre is old or damaged, it is time for a professional inspection. Age matters too: a tyre can be worn out by time even with tread left.

What causes tyres to wear on the inside edge?

For how to store tyres, usually an alignment problem, most often too much negative camber or excessive toe. Worn suspension parts can cause the same pattern. The fix is to have the alignment checked and any worn parts replaced before fitting new tyres, or the new tyres will wear the same way.

How long do tyres usually last?

For how to store tyres, there is no single figure: it depends on the tyre, the car, the roads and how it is driven. Tread depth, age and condition decide when a tyre is finished, not a calendar figure. Measure the tread, check the date code on the sidewall and inspect for damage, and let those readings — not a guess — decide.